Here is a design for a full-featured motor shield that will be able to power many simple to medium-complexity projects. * 2 connections for 5V ‘hobby’ servos connected to the Arduino’s high-resolution dedicated timer – no jitter! - 4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes. Can run motors on 4.5VDC to 36VDC. - Up to 4 bi-directional DC motors with individual 8-bit speed selection (so, about 0.5% resolution) - Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping. - Pull down resistors keep motors disabled during power-up - Big terminal block connectors to easily hook up wires (10-22AWG) and power - Arduino reset button brought up top - 2-pin terminal block and jumper to connect external power, for seperate logic/motor supplies - Tested compatible with Arduino Mega, Diecimila & Duemilanove - Download the easy-to-use Arduino software library, check out the examples and you’re ready to go! The motor drive, can also drive 4 dc motor can be 600MA through each motor, motor can be run in to the 36V voltage between 4.5 V.Can also drive two stepper motor and two steering gear.